Yoder Smokers Silicone Plug for Probe Port — Frequently Asked Questions
What is the Yoder Smokers Silicone Plug for Probe Port?
This is a replacement silicone plug designed to seal the probe port hole on Yoder Smokers models (especially YS480 / YS640 pellet grills). It keeps heat, smoke, and moisture from leaking when the port is not in use.
Which grill models is this plug compatible with?
It is intended for Yoder Smokers YS480 and YS640 pellet grill models.
How do I install or use this plug?
• Insert the silicone plug into the open port hole after the probe has been removed.
• Ensure it is seated snugly to maintain a good seal.
• The plug is often used in conjunction with the factory probe port cover when you want to close the port off completely.
• This plug is part of the factory installation instructions for Yoder probe ports.
How should I maintain or care for the plug?
• Clean it occasionally with warm soapy water to remove soot, smoke residue, or grease.
• Rinse thoroughly and allow it to dry before reinserting.
• Inspect it periodically for wear, tears, or deformation—replace it if it no longer seals properly.
What are its advantages and limitations?
Advantages:
• Maintains seal when probes are not in use, preserving temperature stability
• Simple, low-cost replacement part
• Compatible with factory ports and designs on relevant Yoder models
Limitations:
• Only fits specific Yoder models (YS480/YS640) — not necessarily usable on other grills
• Silicone may degrade over long time in extreme heat or exposure conditions
• Must be properly seated to ensure a leak-tight seal
