Napoleon 10′ Natural Gas Hose with ½″ Quick Connect — Frequently Asked Questions
What is the Napoleon 10′ Natural Gas Hose with ½″ Quick Connect?
This is a 10-foot natural gas extension hose made by Napoleon featuring a ½″ quick-connect fitting. It lets you extend the distance between your grill and gas supply line.
What are its specifications and features?
• Length: 10 ft (≈ 3.05 m)
• Fitting: ½″ quick-connect on one end for easy attach/detach to compatible grills
• Model / MPN: S85003
• Flexible Gray hose designed for natural gas usage (not for propane unless explicitly rated)
• Allows repositioning of your grill setup by providing extra reach from the gas line
How do I install and use it safely?
1. Turn off the gas supply and ensure the grill is shut down.
2. Disconnect the original gas hose or adapter if present.
3. Attach the ½″ quick-connect fitting to the grill’s natural gas port (if compatible).
4. Connect the opposite end to your main gas line or regulator (ensuring matching fitting sizes).
5. Restore the gas supply slowly, then use a soapy water solution to check all connections for leaks (bubbles indicate a leak).
6. If leaks appear, turn off gas again, tighten or re-seat fittings, then retest before use.
How should I care for and maintain it?
• Periodically inspect for signs of wear, cracking, or abrasion along the hose.
• Check the quick-connect fitting for debris, damage, or corrosion and clean gently if needed.
• Avoid kinks, sharp bends, or tension that might stress the hose material.
• During long periods of nonuse, relieve pressure and inspect before reuse.
• If any leak or damage is detected, replace the hose rather than attempting patch repairs.
What are its advantages and potential limitations?
Advantages:
• Provides an extra 10 ft of reach for flexible grill placement
• Quick-connect fitting makes setup and removal easier
• Helps reduce strain on rigid piping or fixed lines
Limitations / cautions:
• Only suitable for **natural gas** systems (unless otherwise rated).
• The flow capacity is limited by the hose’s internal diameter and length—long runs or multiple fittings may reduce pressure.
• Fittings must match (½″ QC on one end, corresponding connector on the other)
• Installation must follow local codes and manufacturer instructions to ensure safety
